Support User Manuals

Enterasys Networks A2H124-24P Switch User Manual

Open as PDF

of 82

Installing the Switch on a Flat Surface

SecureStack A2 PoE Installation Guide 3-3

Installing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubber feetis

recommendedtopreventtheswitchfromslidingonaflatsurface.Installingtherubber

feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed

to“Installingthe

RubberFeet”instructionsbelow.Forinstructionstorackmountthe

switch,proceedto“RackMountingtheSwitch”onpage 3‐6.

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure 3‐1andproceedasfollows:

1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe

chassis.

2. Removethefourrubberfeetfromtheirplasticbagintheshippingbox.

3. Locatethefourmarkedlocationson

thebottomfourcornersofthechassis.

4. Removetheprotectivestripfromthebackofonerubberfootandpositionitona

markedlocationandpressfirmlyintoplace.Repeatthisproceduretoinstallthe

remainingthreerubberfeetintheotherthreelocations.

5. Afterinstallingtherubberfeet,returnthe

switchtoitsuprightposition.

6. Proceedto“GuidelinesforFlatSurfaceInstallation”onpage 3‐5.Forarackmount

installation,proceedto“RackMountingtheSwitch”onpage 3‐6.

previous next