Filter
Top Products
19
The KP6-FX 2 supports different type of settings for the system memory. There is
no jumper nor connector needed for memory configuration. The following figure
provides all possible memory combinations.
SIMM = 4MB, 8MB, 16MB, 32MB, 64MB, 128MB
Fastpage or EDO mode SIMM
DIMM = 8MB, 16MB, 32MB, 64MB, 128MB, 512MB
Fastpage or EDO mode DIMM (3.3 volt unbuffered
recommended)
NOTE :
1. KP6-FX 2 supports and extends many memory configurations on its 4 SIMM & 2
DIMM sockets. The memory size of any configuration is very flexible. You can
combine any configuration as you like. The BIOS will detect your memory
configuration and size automatically, as long as you fill up a bank of memory.
2. KP6-FX 2 supports Fast Page Mode DRAM, EDO DRAM SIMMs, but they
cannot be mixed within the same memory bank.
3. SIMMs/DIMMs may be parity (x 72) or non parity (x 64) or ECC (x 72).
4. The 60ns or 70ns Fast Page, EDO DRAM is necessary.
5. ONE “BANK” = 64 Bit = SIMM 1+ SIMM2 = SIMM 3+ SIMM 4
= DIMM 1 = DIMM 2
2-4 Memory Configurations
Installation 2-7