Filter
Top Products
FeaturesKP6-LA
Page 2-1
Section 2
FEATURES
KP6-LA Features:
• KP6-LA is based on the Pentium
®
II Processor operating at 233 ~ 330 MHz
on Slot 1. The board is configured by an Easy-Setting-Single-Jumper
(E.S.S.J.) to match your CPU clock speed.
• Designed with Intel’s 82443 LX AGPset.
• Supports up to 1 Gigabyte of DRAM (minimum of 8 MB) on board, You
can use either 72-pin SIMM x 4 or 168-pin DIMM x 3 or both. (1 Bank is
shared between the SIMM & DIMM) It will automatically detect Extended
Data Output (EDO) DRAM or Synchronous DRAM memory (SDRAM)
(please see Section 3-2).
• KP6-LA will support Error Checking and Correcting (ECC) when using
parity DRAM memory modules. This will detect multiple bit errors and
correct 1-bit memory errors.
• Supports (3) 16 bit ISA slots, (4) 32 bit PCI slots, (1) AGP slot and provides
(2) independent high performance PCI IDE interfaces capable of supporting
PIO Mode 3/4 and Ultra DMA 33 devices. The KP6-LA supports (4) PCI
Bus Master slots and a jumperless PCI INT# control scheme which reduces
configuration confusion when plugging in PCI card(s).
• Supports ATAPI (e.g. CD-ROM) devices on both Primary and Secondary
IDE interfaces.
• Designed with Winbond W83977 Multi I/O: (1) floppy port, (1) parallel
port (EPP, ECP), and (2) serial ports (16550 Fast UART).
Note: Japanese “Floppy 3 mode” is also supported
• Includes a PS/2 mouse connector.
• Allows use of a PS/2 or AT keyboard.
• Features Award Plug & Play BIOS. With Flash Memory you can always
upgrade to the current BIOS as they are released. (http://www.epox.com/
please visit our Technical Support section for the latest updates)