Filter
Top Products
Installation KP6-LA
Page 3-10
Now we are ready to install the SEC Cartridge (Pentium II Processor) into the
Retention Module. The SEC Cartridge is mounted by sliding the SEC Cartridge into
the Retention Module and letting it slide all the way down. Once it reaches the
bottom make sure you press firmly on SEC cartridge to firmly secure into the Slot 1
Socket.
Now we need to secure the heatsink with the top half of the support (figure 11).
Take the top piece of the support and slide it into the bottom fin (figure 11) on the
heatsink and then push forward until it clips into the bottom base (figure 9) that is
already there (figure 11).
Large Hole for Heat Sink Base
Small Hole for Heat Sink Base
Figure 10
Figure 11
Top half of the support
Bottom fin
of heatsink
Bottom fin
of heatsink
Motherboard
Layout
Figure 9 shows the layout of Slot 1 and the holes for mounting the Heatsink base
piece (figure 8).