Epson 1940W Projector User Manual


 
Securely connected at both ends
Not connected to an extension cable
No longer than 10 feet (3 m) for VGA/PC cables or 24 feet (7.3 m) for HDMI cables
Check the settings on the projector's Signal menu to make sure they match the video source. If
available for your video source, adjust the Progressive and Noise Reduction settings.
Select a computer video resolution and refresh rate that are compatible with the projector.
If you are projecting from a computer, press the Auto button on the remote control to automatically
adjust the Tracking and Sync settings.
If you adjusted the image shape using the projector controls, try decreasing the Sharpness setting to
improve image quality.
If you connected an extension power cable, try projecting without it to see if it caused interference in
the signal.
Parent topic: Solving Image or Sound Problems
Related references
Input Signal Settings - Signal Menu
Supported Video Display Formats
Related tasks
Displaying From a PC Laptop
Displaying From a Mac Laptop
Solutions When the Image is Fuzzy or Blurry
If the projected image is fuzzy or blurry, try the following solutions:
Adjust the image focus.
Clean the projector lens.
Note: To avoid condensation on the lens after bringing the projector in from a cold environment, let the
projector warm up to room temperature before using it.
Position the projector close enough to the screen.
Position the projector so the keystone adjustment angle is not so wide that it distorts the image.
Turn on automatic keystone adjustment in the projector's menus.
Adjust the Sharpness setting to improve image quality.
166