Epson 1940W Projector User Manual


 
If available, turn off one of the remote receivers in the projector's menu system, or check if all the
remote receivers were turned off.
If you assigned an ID number to the remote control to operate multiple projectors, you may need to
check or change the ID setting (feature not available with all projectors).
If you lose the remote control, you can order another one from Epson.
Parent topic: Solving Projector or Remote Control Operation Problems
Related references
Projector Feature Settings - Settings Menu
Projector Setup and Installation Options
Remote Control Operation
Related tasks
Setting the Remote Control ID
Solutions to Password Problems
If you cannot enter or remember a password, try the following solutions:
You may have turned on password protection without first setting a password. Try entering 0000 using
the remote control.
If you have entered an incorrect password too many times and see a message displaying a request
code, write down the code and contact Epson. Provide the request code and proof of ownership for
assistance in unlocking the projector.
If you lose the remote control you cannot enter a password. Order a new one from Epson.
Parent topic: Solving Projector or Remote Control Operation Problems
Solutions When Network Alert E-Mails are Not Received
If you do not receive an e-mail alerting you to problems with a projector over the network, try the
following solutions:
Make sure the projector is turned on and connected to the network correctly. (If an error shut down the
projector, it cannot send an e-mail.)
Make sure you set up the projector e-mail alert settings correctly on the projector's network Mail menu
or in the network software.
Set the Standby Mode setting to Communication On so the network software can monitor the
projector in standby mode.
170