Filter
Top Products
PowerLite S5 Series / 77c Projector
10 - PowerLite S5 Series / 77c Projector 3/08
Changing Presentation Slides
You can use the remote control to click through slideshow-style
presentations (such as PowerPoint
®
) from up to 20 feet away.
This gives you more flexibility, since you don’t need to stand
near your computer to change slides.
To change slides with the remote control, make sure you have
connected your computer to the projector with a USB cable.
To advance slides in a
PowerPoint presentation in
Slide Show mode, press the
Page up button on the remote
control.
Press the
Page down button
to go back a slide.
Note:
You cannot use the remote control as a mouse.
Projector Status Lights
The lights on top of the projector indicate the projector’s status
and let you know when a problem occurs.
If the projector is not working correctly, first turn it off and
unplug it. Then plug the power cord back in and turn on the
projector. If this does not solve the problem, check the status
lights on top of the projector and try the solutions
recommended in the following table.
Power
light
Lamp
light
Temp.
light Description
Flashing
red
Flashing
red
Flashing
red
There is an internal error in the
projector. Turn the projector off
and unplug it. Contact Epson for
help.
Red Off Flashing
red
There is a problem with the fan
or a sensor. Clean the air filter
and air vents. If this does not
solve the problem, turn the
projector off and unplug it.
Contact Epson for help.
Lamp light
Power light
Temperature light
— Flashing
orange
Off Replace the lamp with a new
one as soon as possible. If you
continue to use the lamp, there
is a risk it may break.
Red Flashing
red
Off The lamp is burned out, broken,
or not installed correctly; or the
lamp cover is open. Close the
cover or replace or reseat the
lamp, if necessary. Also, clean
the air filter and air vents. If you
are using the projector at an
altitude above 4900 ft (1500 m),
turn on High Altitude mode as
the Operation setting in the
Extended menu. If these
suggestions don’t work,
contact Epson.
Red Off Red The projector has overheated
and turned itself off. Let it cool
for about five minutes, then
turn it back on. Make sure there
is plenty of space around and
under the projector for
ventilation. Also clean the air
filter and air exhaust vents. If it
continues to overheat, you may
need to replace the air filter.
Red Off Flashing
orange
The projector is too hot. Make
sure the temperature
surrounding the projector does
not exceed 95
°F (35 °C) and
there is plenty of space around
and under the projector for
ventilation. Clean the air filter
and air vents, if necessary.
Seepage12 for instructions.
Flashing
orange
Off Off The projector is shutting down.
Wait for the light to stop
flashing and remain orange
before unplugging it.
Orange Off Off The projector is in standby or
sleep mode. You can unplug it
or press the
P Power button to
turn it on.
Flashing
green
Off Off The projector is warming up.
Wait for the image to appear.
Green Off Off The projector is operating
normally.
Power
light
Lamp
light
Temp.
light Description