Filter
Top Products
Epson PowerLite Pro Cinema 800
4 - Epson PowerLite Pro Cinema 800 11/05
Cable Connections
You can connect up to five pieces of video equipment to the
projector, using the ports listed below (cables are not included):
For best results, connect your video equipment to the
HDMI (High-Definition Multimedia Interface) port. If your
equipment doesn’t support HDMI, connect it to one of the
following ports (highest quality listed first): Input A (for
component video), S-Video, or Video (composite video).
Making Other Connections
Depending on how you plan to use the projector, you may need
to connect these additional cables:
❏ Control (RS-232C)
Connect a computer or AV controller to this port.
❏ Trigger out port
This port outputs a 12-volt DC signal when the projector is
turned on, and can be used to raise or lower a projection
screen automatically.
❏ Connect a 3.5-mm mini jack to the port, as shown.
Source
change
Terminal Signal name
Input A Input A SOURCE 10
YCbCr SOURCE 14
YPbPr SOURCE 15
Auto SOURCE 1F
Input B Input B SOURCE 20
RGB SOURCE 21
Input 3
(HDMI)
HDMI SOURCE 30
Video Cycles within
SOURCE 4X
SOURCE 40
Video (RCA) SOURCE 41
S-Video SOURCE 42
Input 5 D4 SOURCE C0
YCbCr SOURCE C4
YPbPr SOURCE C5
Auto SOURCE CF
Color Mode Standard CMODE 01
Cinema Night CMODE 05
Cinema Day CMODE 06
Natural CMODE 07
Vivid CMODE 08
HD CMODE 09
Silverscreen CMODE 0A
Aspect ratio Auto ASPECT 00
Normal ASPECT 20
Squeeze ASPECT 21
Zoom ASPECT 22
Through ASPECT 23
Squeeze
Through
ASPECT 24
Wide ASPECT 25
Item Command
Port Required Cable Supported video formats
Video RCA video cable Analog TV (NTSC, PAL, SECAM)
S-Video S-video cable Analog TV (NTSC, PAL, SECAM)
Input A Use a 3-connector
component video cable.
Select YCbCr (NTSC) or
YPbPr (HDTV) as the
Input Signal setting (see
page 6)
Digital TV (SDTV and HDTV)
Analog TV (NTSC, PAL, SECAM)
Input B Mini D-sub, 15-pin
monitor cable
RGB
HDMI HDMI cable Digital TV (SDTV and HDTV)