Filter
Top Products
Epson PowerLite Pro Cinema 800
11/05 Epson PowerLite Pro Cinema 800 - 9
Cleaning and Replacing the Air Filter
Clean the air filter on the bottom of the projector once every
three months, or more often in dusty environments. If it’s not
cleaned periodically, it can become clogged, preventing proper
ventilation. This can cause overheating and damage the
projector.
1. Press the P
Power button and wait for the P power light to
stop flashing.
2. Turn off the projector using the power switch on the back.
3. Unplug the power cord and disconnect any cables.
4. Turn the projector over.
5. Then use a small vacuum cleaner designed for computers
and other office equipment to clean the filter. If you don’t
have one, gently clean the filter using a very soft brush, such
as an artist’s paintbrush.
If the dirt is difficult to remove or the filter is broken, replace
it. Purchase part number
V13H134A09 from an authorized
Epson reseller.
6. If you need to replace the filter, release the tab and lift up the
cover.
7. Remove the old filter and replace it with a new one.
8. To replace the cover, insert the tabs and press down until the
cover clicks into place.
Replacing the Lamp
The projection lamp lasts from 1700 to 3000 hours, depending
on usage. You can use the Info menu to check how long it’s
been in use. It’s time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The projector’s warning light flashes red at half-second
intervals.
❏ The message
Replace the lamp appears on the screen when
you start projecting.
Note: Lamp life results will vary depending on the selected mode,
environmental conditions, and usage.
Purchase lamp part number
V13H010L35 from an authorized
Epson reseller.
Warning: Let the lamp cool fully (about an hour) before replacing
it. In the unlikely event that the lamp has broken, small glass
fragments may be present and should be removed carefully to avoid
injury.
Caution: Never touch the lamp with your bare hands; the invisible
residue left by the oil on your hands may shorten the lamp life. Use
a cloth or glove to handle the new lamp.
Follow these steps to replace the lamp:
1. Press the P
Power button and wait for the light to stop
flashing.
2. Turn off the power switch on the back of the projector and
unplug the power cord and any cables.
3. If the projector has been on, let it cool for about an hour.
4. Press in the latches securing the lamp cover and lift off the
cover.