Filter
Top Products
14
Remote control
Remote control
►
Be careful of handling a battery, as a battery can cause explosion,
cracking or leakage, which could result in a re, an injury, and environment pollution.
•
Use only the specied and new battery. Do not use a battery with damage, such
as a scratch, a dent, rust or leakage. Do not mix a new battery with used one.
•
When a battery leaked, wipe the leakage out well with a waste cloth. If the
leakage adhered to your body, immediately rinse it well with water. When a battery
leaked in the battery holder, replace the batteries after wiping the leakage out.
•
Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Do not work on a battery; for example recharging or soldering.
• Do not keep the batteries put into the remote control when the remote control
is not used for a long while. Keep a battery in a dark, cool and dry place. Never
expose a battery to a re or water.
• Obey the local laws on disposing a battery.
WARNING
• Try changing the batteries when the
remote control malfunctions.
• This remote control works with the remote
sensors on the projector using infrared light
(Class 1 LED). The active sensor senses the
remote control signal assigned within 60 degrees
to right and left, and within 3 meters.
• The remote control signal reected in the
screen or the like may be available.
• Prevent the remote sensors from being hit by
a strong ray. It may cause malfunction of the
projector and remote control.
NOTE
Preparing for the remote control
The accessory remote control needs batteries. Use the
batteries included in this product or two new batteries of
the specied type: HITACHI MAXELL, part number LR6
or R6P. Follow the following procedure.
Remote sensors
3 m
(approx.)
30º
30º
1.
Remove the battery cover in the back of the remote
control.
2.
Put the batteries into the battery holder, according to
the polarity markings (+) and (-) inside the holder.
3.
Put the battery cover back to the former state.