Filter
Top Products
61
Maintenance
Maintenance
2.
Loosen the screw (marked by arrow) of the
lamp cover, and then slide the lamp cover to
the side to remove it.
3.
Loosen the 2 screws (marked by arrows) of
the lamp, and slowly pick up the lamp by the
handles.
4.
Insert the new lamp, with cautions not to
touch the inside of the lamp house. When
inserting, pay attention to the socket position
rst, and to the pins for positioning next.
5.
Tighten rmly the 2 screws of the lamp that
are loosened in the previous process to lock
it in place.
6.
Slide the lamp cover into place and rmly
tighten the screw of the lamp cover.
7.
Plug in and restart the projector (12, 16).
Then, reset the lamp time (which is the time
counter for the lamp use).
Replacing the lamp
The projection lamp has nite product life that is different in each lamp. Please replace the
lamp as soon as possible when the pictures appear dark, or when the color tone is poor.
Using the lamp for long periods of time may make the lamp burned out or broken.
Preparation of a spare lamp and early replacement are recommended. To prepare the new
lamp, call your dealer and tell the type number: 456-8100
(1) Press the ▲ or ▼ button on the projector
or the MENU button on the remote control.
The “EASY MENU” appears.
(2) Point at the “Go to Advanced Menu …”
in the menu using the ▲ or ▼ button, then
press the ► button. “MENU” appears.
(3) Pointed at the “OPTION” in the left column using the ▲ or ▼ button, then press
the ► button. The cursor moves to the right column.
(4) Pointed at the “LAMP TIME” using the ▲ or ▼ button, then press the ► button.
A dialog appears.
(5) Press the ▲ button to select the “RESET” on the dialog. It performs resetting the
lamp time.
When the projector is mounted on a ceiling or somewhere over your head, or when the
lamp may have been broken, be sure to refer replacement to your dealer or service person,
since it may be dangerous.
Only in case of replacement by yourself, follow the following procedure.
1.
Turn the projector off and unplug the power cord from the power outlet.
And cool the projector down by leaving it for about 45 minutes as it is.
Lamp house
(inside of the
lamp cover)
Lamp cover
Screw
Pin for
positioning
Socket
Screw
Pin for positioning