Filter
Top Products
4.
Click Protocol and then the Add button.
5.
Select Microsoft from the Manufacturers list and TCP/IP from
the Network Protocols list. Then click OK.
6.
Click OK again and follow any on-screen instructions to enable
TCP/IP.
Configuring the Ethernet Card for TCP/IP and Windows 95
Make sure that the Ethernet card installed in the printer is on the
same network segment as the computer you are using to configure
the card. Also, find out that computer’s IP address and the IP
address that you will assign to the Ethernet card.
Note:
lf you do not know how to find out your computer’s IP address
or
the IP
address for the Ethernet card, ask your network administrator, or follow
the instructions that follow this section.
Follow these steps to configure the card:
1.
Find the hardware address (node number) on the top of the
status sheet you printed out after initializing the card. (See
page 2.) If you need to, print out another status sheet.
2.
Double-click the MS-DOS Prompt icon to open a DOS prompt.
3.
Set up the routing table, using the following command:
ping <IP address>
for example: ping 127.0.1.1
4.
Add an entry in the ARP table that assigns an IP address to the
hardware address of the Ethernet card. Use the following
command:
arp
-s <IP address> <node address>
for example: arp -s 127.0.1.200 00:00:48:92:BD:9A
5.
Start a continuous “ping” to the card, using the following
command with the card IP address:
ping
<IP
address>
for
example: ping 12'
You see a message
sim
Reply from
127.0.1.21
Reply from 127.0.1.2
Reply from 127.0.1.2
Reply from 127.0.1.2
This shows that the
Etherne
If you receive 4 lines of
“Ret
correctly. Check to make
su
segment as the workstation
you typed in the correct II’
q
Before you can print using
’
Monitor and add a printer
I
User’s
Guide for instruction:
Note About
IP
Addresses
ar
If you don’t have a network
addresses in the range of
19
computer or other device
c(
have a unique IP number. T
However, you should not u
direct (rather than dial-up)
10
EPSON Ethernet Card Supplement