Filter
Top Products
Submenu Function
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button for about five seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
Direction
Set this parameter according to the installation status of the
projector.
s "Installation Requirements" p.20
Submenu Function
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
High Altitude Mode: Set to On when using the projector
above an altitude of 1500 m.
BNC Sync Termination: Set the termination for the signal
from the BNC port. This should usually be set to Off. Set to
On when analog (75Ω) termination such as for switchers is
necessary.
Remote Control Type: You can select Normal or Simple
depending on the type of remote control.
Set this item to Normal to use the remote control provided
with this projector. When Simple is selected, you can use
the remote control provided with other Epson projectors to
operate this projector. This is useful if you want to use a
remote control that you are already familiar with to operate
the projector.
However, you cannot use the remote control provided with
this projector if this is set to Simple. Make sure that the
setting is correct because, if the projector is mounted on the
ceiling or somewhere hard to reach, changing it back to
Normal may be difficult. Additionally, you cannot use the
functions that are not equipped with this projector or the
remote control which you use.
Inv Direction Button: Set this to On when the projector is
installed on a ceiling.
List of Functions
87