Filter
Top Products
112 - Replacing the Lamp
EMP-715/505E mainte.fm
Replacement method
1
Switch off the power supply, allow the projector to cool down*, and then disconnect the
Power Cord.
The amount of time required for the projector to cool down will depend on the surround-
ing temperature.
2
Wait until the lamp has cooled down sufficiently, and then remove the lamp cover.
· Approximately one hour is required for the lamp to cool down sufficiently.
· Loosen and remove the screw holding the fan in place.
3
Withdraw the lamp.
Loosen the two screws holding the lamp in place, and then pull the lamp out towards you.
4
Attach a new lamp.
Align the direction, push the lamp in as far as it will go, and then secure it in place with
the two screws.
715_505E.bk Page 112 Friday, May 25, 2001 10:24 AM