Filter
Top Products
90 - When the Indicators Provide No Help
The image is distorted
·The image is
disturbed.
·Noise appears
●
Has the cable been connected correctly?
see page 27
, 37
●
Is the selected resolution correct?
Align the computer with the signals supported by the projector. Refer
to the computer’s instruction manual for details on how to amend the
signals.
see page 27
●
Has the [Sync.*, Tracking* and Position] been adjusted?
The image can be adjusted by regulating the [Tracking] and [Sync]
buttons on the projector while monitoring the image on screen.
Adjustments can also be made by opening the [Menu].
see page 51
, 68
●
Has the cable length been extended?
There are cases where noise will occur if the cable length is extended.
●
Has the signal format setting for the image been set correctly?
· In the case of computer images:
Set the signal format with [Menu] − [Image] − [Resolution]. There are
cases where the image signals being input cannot be determined in
the [Auto] mode.
see page 68
· In the case of video images:
Select the video signal format with [Menu] − [Image] − [Video Signal
Format]. There are cases where the video image signals being input
cannot be determined in the [Auto] mode.
see page 69
·The image is cut
up
·The image is small
●
There is a possibility that the [Resize] setting has not been correctly
selected.
Press the [Resize] button.
see page 56
●
Has the [Position] been adjusted?
Adjust with [Menu] − [Image] − [Position].
see page 68
●
Is the selected resolution correct?
Align the computer with the signals supported by the projector. Refer
to the computer’s instruction manual for details on how to amend the
signals.
see page 27
●
Amend the resolution for note-type and liquid crystal type
computers.
Either amend the resolution so that the display fills the entire screen,
or set the image signals so that only external output is possible.
see page 27