Filter
Top Products
EPL-6000 LASER PRINTER
Cleaning the laser beam lens
Note: Cleaning the lens is required at an interval of 10,000 pages
(the same interval as for changing the drum). If you wish, you can
clean the lens when you change the drum and skip this procedure
when you change the toner cartridge. If you plan to skip this
procedure. go to step 3 for information on reassembling your
Follow these steps to clean the laser beam lens:
1.
Locate the lens, which is the clear plastic component inside the
top cover of your printer.
2Clean the lens with a lens cleaning cloth or other clean, soft
cloth. Do not use alcohol
Raised printer cover
3.
To ready your printer for printing reinstall your basket. (Press
down simultaneously
on the drum unit’s two green handles
until the drum unit clicks into place.) Then close the printer
cover. Plug in the power cord and turn your printer back on.
4.
Gently clean the main charger wire with a cotton swab dipped
in alcohol. Run the swab along the length of the wire. You need
to insert the cotton swab a fraction of an inch into the slot to
reach the wire.
5.
With the top cover of the printer open, align the arrow on the
back of the basket with the
arrow on the printer case. (The
arrows point toward each other when the unit is properly
installed.) Gently lower the basket into place.
Cleaning the transfer charger and discharge wires
Follow the steps below to clean the transfer charger wire and
discharge wire.
Note: Locate some isopropyl alcohol to use for cleaning purposes
before
proceeding
1.
Make sure the printer is turned off, then disconnect the power
cord from the wall outlet. Also be sure that the printer cover is
open and that the basket is removed from the printer.
WARNING: This procedure exposes the green drum unit,
which is in the basket. Because the drum is light-sensitive,
minutes, maximum.
It is recommended that you cover the
drum unit with a soft cloth or sheet of paper whenever the
2
3.
drum is exposed.
Locate a cotton swab.
with the printer cover open, locate the
transfer charger wire and
the discharge wire, which are in indentations at the bottom of
the printer, beneath where the basket normally rests. These
wires are thin and difficult to spot instantly.
Transfer charger wire
I
General Printer Maintenance
In addition to the maintenance called for by the display panel
messages, the following simple maintenance procedures may be
occasionally necessary:
l
Cleaning the developer unit. You should clean the developer
unit if vertical white lines appear on your printed page.
l
Cleaning the main charger wire. You should clean this wire if
print quality declines.
These procedures are described below.
Cleaning the developer unit
If vertical white lines appear on your printed page, you need to
clean the developer unit with the developer cleaner. Follow these
steps:
1.
Locate the developer cleaner. A cleaner is included with the
accessory pack that comes with your printer. A cleaner is also
packed with replacement drum units.
EPL-8 7/18/89
Laser Printers