Epson C64 Printer User Manual


 
EPSON Stylus C64
8/03 EPSON Stylus C64 - 7
Low ink: When the red H ink light flashes, one or more ink
cartridges are low on ink. When you print, you’ll also see a
message on the screen telling you which cartridge is low.
Empty cartridge: When the red H ink light stays on, you need
to replace the cartridge(s). When you print you’ll also see a
message on the screen telling you which cartridge is empty.
1. Turn on the printer.
2. Lower the printer’s output tray, pull out the extension, and
open the cover.
3. Press and release the H ink button. The print head moves to
the left, and the cartridge that needs to be replaced stops
under the _ ink out mark.
The P power light also begins to flash.
4. Press the H ink button again.
If more than one cartridge is empty, the next cartridge
moves under the _ ink out mark.
If all the empty cartridges have been identified, the print
head moves to the ink cartridge replacement position.
Note:
You can also use the Status Monitor to find out which cartridge is out
of ink. See your online User’s Guide for more information.
5. Open the cartridge cover.
6. Pinch the back tab of the empty cartridge as you lift it out of
the printer.
7. Before you remove the new cartridge from its package,
shake it four or five times.
8. Unwrap the new ink cartridge and lower it into the holder.
Push down gently until the cartridge is firmly seated.
Caution
Don’t touch the green circuit board on the front of the cartridge;
you may inhibit normal operation and printing.
9. If you need to replace other ink cartridges, repeat steps 5
through 7 before continuing with step 10.