Filter
Top Products
Connecting the Scanner to the Computer
Use this procedure to connect the scanner directly to the SCSI
port on your computer using the cable included in the scanner
package.
If you are already using the SCSI port on your computer for
another SCSI device, such as an external hard drive, see
Chapter
1
of the
ES-1200C User’s Guide
for information on
including the scanner in a daisy-chain arrangement.
Caution:
Be sure that your
computer,
scanner, and any other peripheral
devices are turned off before you plug in the cables.
1.
Connect the 50-pin end of the cable to either the top or
bottom SCSI connector of the scanner; then fasten the
connector with the clamps on the sides of the connector, as
shown.
2.
Plug the other end of the interface cable into the connector
of the SCSI interface card you installed in the computer.
Fasten the connector with the wire clamps.