Filter
Top Products
Chapter 6
Troubleshooting
Using the Error Indicators
You can identify many common printer problems using the lights on the control panel. If your printer
stops working and one or more control panel lights are on or flashing or the printer beeps, use the
following table to diagnose and fix the problem. If you cannot fix your problem using this table, see
“Problems and Solutions” on page 57.
Panel light state Beep pattern Problem
Solution
N On
N Paper
O
No paper is attached to the tractor unit or the paper is used up during
printing.
Attach the paper to the tractor, and then press the Load/Eject
button.
N On
F Paper
O
The paper is not fully loaded.
Remove the paper if there is a paper jam. Then, reattach the paper to
the tractor and press the Load/Eject button.
The paper is not ejected completely.
If the paper is advanced too far and ejection failed, press the Load/
Eject button again to feed the paper backward. However, to prevent
a paper jam, do not feed the paper backward 558.8 mm (22 inches) or
more.
If the length of the paper that you want to eject is longer than about
550 mm (22 inches), tear off the paper, and then press the Load/
Eject button.
N On
N Cover
- The top cover or ink cartridge cover is open.
Close the covers.
GP-C830/GP-M830/GP-C831/GP-M831/GP-C832/GP-M832 User’s Guide
Troubleshooting 55