Filter
Top Products
Epson SureColor T-Series User’s Guide
Copying and Scanning
74
O Documents with rips
How to Load Documents
Before you load a document with the thickness of 0.25
mm or larger, carry out the following three actions.
Remove the paper eject guides (when document
thickness is 0.25 mm or more)
Remove all paper eject guides of the scanner.
If the paper eject guides are left attached, the document
will strike them and not be ejected.
Set the document eject direction to forward (when
document thickness is 0.25 mm or more)
Make sure the document eject direction is forward.
If the document is ejected backward with the paper
eject guides removed, the document will fall to the rear
side and be damaged by folding or dirt.
U“Changing the document eject direction” on page
77
Ensure forward and backward space (when
document thickness is 0.25 mm or more)
When the document is read, it is pushed out forward
and backward. The approximate amount of space
required is shown below. If the printer is set up near a
wall, make sure there is enough space at the rear.
Loading documents
1
Align the loading guide with the document
loading position.
To ensure that the document is not fed on an
angle, we recommend inserting the long side of
the document.
Paper Size Forward (a) Backward (b)
A2 185mm 220mm
A1 432mm 467mm
24 × 30 inch 353mm 388mm
30 × 40 inch 607mm 642mm