Filter
Top Products
FENIX IMVICO
TK14 OPERATION MANUAL
36/65
ESC a
n
[Name] Select justification
[Format] ASCII ESC a
n
Hex 1B 61
n
Decimal 27 97
n
[Range] 0
≤
n
≤
2, 48
≤
n
≤
50
[Description] Aligns all the data in one line to the specified position
n
selects the justification as follows:
n
Justification
0, 48 Left justification
1, 49 Centering
2, 50 Right justification
[Notes]
•
The command is enabled only when processed at the beginning of the line.
•
This command executes justification in the printing area.
[Reference]
ESC !
[Example]
Left justification Centering Right justification
ESC c 3
n
[Name] Select paper sensor(s) to output paper end signals (PE in parallel interface)
[Format] ASCII ESC c 3
n
Hex 1B 63 33
n
Decimal 27 99 51
n
[Range] 0
≤
n
≤
255
[Description] Selects the paper sensor(s) to output paper end signals.
Each bit of
n
is used as follows:
Bit OFF / ON Hex Function
OFF 00 Paper roll near-end sensor disabled0
ON 01 Paper roll near-end sensor enabled
OFF 00 Paper roll near-end sensor disabled1
ON 02 Paper roll near-end sensor enabled
OFF 00 Paper roll end sensor disabled2
ON 04 Paper roll end sensor enabled
OFF 00 Paper roll end sensor disabled3
ON 08 Paper roll end sensor enabled
4-7 - - Undefined
[Notes] The command is available only with a parallel interface and is ignored with a serial interface.
•
It is possible to select multiple sensors to output signals. Then, if any of the sensors detects
a paper end, the paper end signal is output.
•
Sensor is switched when executing this command. The paper end signal switching be
delayed depending on the receive buffer state.
•
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor
outputting paper-end signals
•
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor
outputting paper-end signals.
•
When all the sensors are disabled, the paper end signal always outputs a paper present
status.
[Default]
n
= 12
ABC
ABCD
ABCDE
ABC
ABCD
ABCDE
ABC
ABCD
ABCDE