Filter
Top Products
Rev. C Using the Printer 3-7
TM-C100 Technical Reference Guide
3.3 Maintenance
3.3.1 Ink head cleaning
If the print appears blurred, the ink head nozzles may be blocked. In this case you can return the
printer to its normal performance with ink head cleaning.
Note:
Since cleaning uses ink, avoid ink head cleaning if there is no problem with the print results.
3.3.1.1 Using the switch on the printer
Cleaning starts if the CLEANING switch on the printer is pressed for 3 seconds or more. The
POWER LED flashes during cleaning. Wait until it finishes flashing (1 minute maximum).
Note:
When the POWER LED is flashing (during cleaning), do not open the printer cover or turn off the
printer. When the printer cover is next closed, or when the power is next turned on, cleaning starts again
which wastes ink.
Since cleaning uses ink, avoid ink head cleaning if there is no problem with the print results.
3.3.1.2 Using the maintenance utility of the driver
The Windows driver and OPOS-X come with a utility for maintenance. See the relevant manual
for information on how to use them.
3.3.2 Cautions when transporting the printer
To prevent ink leaking when transporting the printer, take the following precautions.
❏ Remove the ink cartridge before transporting the printer.
❏ Ensure that the printer is kept horizontal. Do not transport it upside down.
❏ Do not transport half-used ink cartridges.
❏ Be sure not to transport any ink cartridge that has been removed from its packing.