Filter
Top Products
28
Setting the mail notification function
The mail notification function can be used to send notification messages to
preset e-mail addresses when a problem or warning occurs with a projector
that is connected to the network. By using this function, the operator can be
notified of problems with projectors even when the operator is in a different
location from the projectors.
PROCEDURE
Select "Mail notification function" from the "Tool"
menu.
The "Set mail notification function" window will be
displayed.
Set the following parameters.
TIP
• Up to three addressees (destinations) can be registered and
messages can be sent to all of them at once.
• If a critical problem develops with a projector which causes it to
suddenly stop working, it may not be possible for the projector to
send a message notifying an operator of the problem.
• If "Standby Mode" is set to "Network ON" or "Network
Monitoring" is set to "ON" in the projector configuration menus,
you can monitor the projector even when it is in standby mode
(when its power is turned off).
sProjector’s User's Guide
• On some projectors, the mail notification function can be set in the
configuration menu. When notification messages are set to be sent
in the projector's configuration menu, both the settings in the
configuration menu and settings made on EMP Monitor are
functional.
1
Mail notification
function
Set to "ON" to use the mail notification function.
SMTP server
IP address
Enter the IP address of the SMTP server.
Up to a maximum of 255 bytes can be entered.
When you change a port number of the SMTP
server, specify this port number. The default value
is "25".
You can enter a valid number from 1 to 65535.
Sender mail
address
Enter the sender's e-mail address. Up to a
maximum of 255 bytes can be entered.
Recipient
mail address 1
Specify the destination addresses for the
notification e-mail. Up to three destinations can be
set. Up to a maximum of 255 bytes can be entered.
Recipient
mail address 2
Recipient
mail address 3
2