Filter
Top Products
Quick Start — CrossPoint 42 HVA, cont’d
Additional Information
View ties
A. Press and release the Conf/Save button to
select audio and/or video.
B. Press and release the output button to select
the desired output (1 or 2). The selected
output and tied input LEDs light.
View and adjust audio level
A. Press and hold the Conf/Save button until
the Audio LED begins to blink.
B. Press and release the desired input button.
The level is displayed by the input LEDs
and the Decrement (
) and Increment ( )
LEDs. Gain or attenuation is indicated by
the Video/+dB (gain), or Audio/-dB
(attenuation) LEDs.
C. Decrease or increase the level by pressing
the Decrement (
) and Increment ( )
buttons until the desired level is reached.
D. Press and release the Conf/Save button to exit.
Front Panel Controls
Input and output buttons and LEDs select and identify inputs and outputs. The input LEDs also
display a portion of the audio level of the selected input.
Conf/Save button selects view mode (video and audio, video only, or audio only) and saves changes
when you change the configuration.
I/O LED indicates the current configuration mode. It is steady when setting up a video and/or audio
tie, and it blinks in audio level display/adjust mode.
Video/+dB and Audio/-dB LEDs indicate when video or audio is selected. The Audio LED blinks to
indicate audio breakaway. The Audio button also selects the audio level/adjust mode. The Video/+dB
LED indicates a positive (+) gain value. The Audio/-dB LED indicates a negative (-) attenuation value.
Decrement (
) button and LED decrements the audio level of the selected input. The LED indicates
a portion of the audio level of the selected input.
Increment ( ) button and LED increments the audio level of the selected input. The LED indicates a
portion of the audio level of the selected input.
Definitions
The following terms are used throughout this manual:
Tie — An input-to-output connection.
Configuration — One or more ties or sets of ties.
Current configuration — The currently active configuration (also called configuration 0).
CONF/SAVE
4
3
2
1
I/O
INPUTS
OUTPUTS
1
2
LED key: = off, = on, = blinking, = blinking slowly, = blinking fast
B2
B1
A
D
and
B
C
B
AUDIO/-dB
VIDEO/+dB
B
CONF/SAVE
4
3
2
1
I/O
INPUTS
OUTPUTS
1
2
A
B
AUDIO/-dB
VIDEO/+dB