Filter
Top Products
RGB 138xi, RGB 158xi Installation and Operation
RGB 138xi, RGB 158xi Installation and Operation
Installation and Operation, cont’d
2-15
Through-desk mounting
1. Attach the through-desk mounting brackets to the
interface with the provided machine screws.
2. Hold the interface with attached brackets against the
underside of the mounting surface of the desk or
table. With a soft pencil mark the location of holes
for screws on the desk. Mark the opening,
approximately 17.63” x 1.88” (44.77 cm x 4.76 cm).
3. Cut out the material from the installation area with a
jigsaw. Check the opening size by inserting the
interface part way through the hole. If needed, use a
saw, file or sandpaper to enlarge the hole. Smooth
the edges of the hole with sandpaper.
4. Drill 1/4” (6.4 mm) deep, 3/32” (2.38 mm) diameter pilot
holes in the desk or table at the marked screw
locations. The holes should be drilled from the
underside or inside (concealed side) of the furniture,
where the interface will be located.
5. Attach the interface to the desk with the provided wood
screws, as shown in the illustration below.
R
G
B
1
3
8
x
i
I
N
P
U
T
S
A
U
D
I
O
A
N
A
L
O
G
U
N
S
W
IT
C
H
E
D
6
00 W
A
T
TS
M
A
X
.
M
IN
/M
A
X
M
B
C
P
O
W
E
R
U
N
I
V
E
R
S
A
L
I
N
T
E
R
F
A
C
E
W
/
A
D
S
P
To adjust the height of the interface within the desk,
slightly loosen the screws that attach the brackets to
the interface, adjust the height by sliding the
interface up or down, and retighten the screws.
2-14
Mounting the Interfaces
Select the installation site. Take cabling and power
availability into consideration. Select an installation option:
tabletop/desktop placement, or under-desk, through-desk
or rack mounting.
Tabletop/desktop placement
For tabletop or desktop placement only, install the self-
adhesive rubber feet/pads (provided) onto the four corners
of the bottom of the interface enclosure.
Under-desk mounting
1. Attach the mounting brackets to the interface with the
provided machine screws, as shown below.
2. Hold the interface with attached brackets against the
underside of the desk or other furniture. Mark the
location of holes for screws on the desk.
3. Drill 1/4” (6.4 mm) deep, 3/32” (2.38 mm) diameter pilot
holes in the table or desk at the marked screw
locations from the underside/inside (concealed side)
of the furniture, where the interface will be located.
4. Attach the interface to the installation surface with the
provided wood screws, as shown below.
R
G
B
1
3
8
x
i
I
N
P
U
T
S
A
U
D
I
O
A
N
A
L
O
G
U
N
S
W
I
T
C
H
E
D
6
0
0
W
A
T
T
S
M
A
X
.
M
I
N
/
M
A
X
M
B
C
P
O
W
E
R
U
N
I
V
E
R
S
A
L
I
N
T
E
R
F
A
C
E
W
/
A
D
S
P
Under-desk mounting