Filter
Top Products
SW2 VGA DA2 AF R • Specifications
SW2 VGA DA2 AF R • Specifications
A-3A-2
Specifications
Video
Gain................................................ Unity
Bandwidth ..................................... 300 MHz (-3dB)
Video input
Number/signal type ................... 2 VGA-UXGA RGBHV, RGBS, RGsB*,
RsGsBs*
Connectors ................................... 2 VGA 15-pin HD female
Nominal level ............................... 0.7V p-p for RGB (excluding sync)
Minimum/maximum levels ....... Analog ....... 0.3V to 1.5V p-p with no
offset
Impedance .................................... 75 ohms
Horizontal frequency .................. 15 kHz to 145 kHz
Vertical frequency ....................... 30 Hz to 170 Hz
Video output
Number/signal type ................... 2 buffered VGA-UXGA RGBHV, RGBS,
RGsB*, RsGsBs*
Connectors ................................... 2 VGA 15-pin HD female
Nominal level ............................... 0.7V p-p for RGB (excluding sync)
Minimum/maximum levels ....... 0.3V to 1.5V p-p
Impedance .................................... 75 ohms
*RGsB and RsGsBs inputs and outputs will work in
manual mode only. Autoswitching requires TTL level sync on pin
13 of the 15-pin HD connector.
Sync
Input type ..................................... RGBHV, RGBS, RGsB*, RsGsBs*
Output type .................................. RGBHV, RGBS, RGsB*, RsGsBs*
Input level ..................................... 2.5V to 5.0V p-p
Output level .................................. TTL: 5.0V p-p, unterminated
Input impedance .......................... High Z
Output impedance ....................... 75 ohms
Max. input voltage ....................... 5.0V p-p
Polarity .......................................... Positive or negative (follows input)
Audio
Gain................................................ Wired for unbalanced output: 0dB;
balanced output: +6dB
Frequency response .................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................. 0.03% @ 1 kHz at nominal level
S/N ................................................ >90dB at rated maximum output
Crosstalk ....................................... <-65dB @ 20 kHz, <-80dB @ 1 kHz and
below 60 Hz
Stereo channel separation .......... >80dB @ 1 kHz
CMRR ............................................ >75dB @ 20 Hz to 20 kHz
Audio input
Number/signal type ................... 2 stereo, unbalanced
Connectors ................................... (2) 3.5 mm female stereo jacks
Impedance .................................... >50 kohms unbalanced, >25 kohms
balanced, DC coupled
Nominal level ............................... -10dBV (316 mV)
Maximum level ............................ +19.5dBu, (balanced or unbalanced) at
1%THD+N
Audio output
Number/signal type ................... 1 stereo, balanced/unbalanced
Connectors ................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Nominal level ............................... -2dBV (632 mV) balanced output
Gain error ..................................... ±0.1dB channel to channel
Maximum level (Hi-Z) ................ >+21dBu, balanced or unbalanced at 1%
THD+N
Maximum level (600 ohm) ......... >+15dBm, balanced or unbalanced at 1%
THD+N
0dBV = 1 volt (RMS).
Control/remote — switcher
Contact closure ............................ Momentary
Contact closure pin configurations 1 = Input #1, 2 = Input #2
Loop signal ................................... Momentary low, 250 µS
General
Power ............................................ 100VAC to 120VAC, 50/60 Hz, 12 watts,
internal, auto-switchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) /
10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) /
10% to 90%, non-condensing
Rack mount .................................. Yes, with included brackets, and furniture
mountable with optional brackets