Filter
Top Products
YCS SW2 • Installation and Operation
Installation and Operation, cont’d
2-4
YCS SW2 • Installation and Operation
2-5
Back of the rack mounting
The YCS SW2 also can be mounted vertically to the front or rear
rack supports, using the optional back of the rack mounting kit
(Extron part #70-367-01).
Follow these steps to mount the YCS to the rack supports using
the back of the rack mounting kit:
1. If feet were previously attached to the bottom of the YCS,
remove them.
2. Remove the two screws from one side of the YCS. Retain
the screws for possible later reassembly.
3. Attach one bracket to the side of the unit, using the longer
screws included in the mounting kit (see fi gure 2-4, below).
4. Repeat steps 2 and 3 on the other side of the YCS.
Figure 2-4 — Attaching the back of rack mounting
brackets to the YCS SW2
5. Mount the unit to the rack support, using the two included
rack screws.
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
1/4 Rack Width Front False
Faceplate
1/2 Rack Width Front False
Faceplate
Figure 2-2 — Mounting a YCS SW2 on a standard
rack shelf
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
Figure 2-3 — Mounting a YCS on a 6-inch rack shelf