Falcon ED4000-A Power Supply User Manual


 
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions which must be followed during the
installation, operation and maintenance of this unit and its battery options. Please
read all instructions before operating this equipment and save this manual for future
reference.
All of the models presented herein are designed for installation and use in a con-
trolled environment free of contamination.
This UPS utilizes voltage that may be hazardous. Do not attempt to disassemble.
This unit contains no user replaceable parts. Refer all servicing to Falcon Electric,
Inc.
This unit is not intended to be used in conjunction with life support or operating
room equipment.
Always unplug this device prior to cleaning and never apply liquid or spray
detergent on the ED unit.
Never attempt to service batteries. High voltage exists within the unit, which could
cause electrical shock. Servicing of batteries should be performed or supervised
by personnel knowledgeable of batteries and the required precautions. Keep unau-
thorized personnel away from batteries. When replacing the optional ED batteries,
use the same number and type of batteries.
If configured with batteries, allow at least 24 hours, after the ED is first installed and
turned on, to fully charge the internal battery and assure the maximum backup time
is available.
DO NOT plug this unit into its own output as this may damage the ED electronics.
DO NOT remove or unplug the input cord when the ED is turned on. This removes
the safety ground from the unit and the equipment connected to the ED.
When configured with optional batteries, the ED contains its own energy
source (batteries). The output receptacles may carry live voltage even when
the UPS is not connected to an AC source.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
IMPORTANT
DO NOT
CAUTION
1