Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
79
Replacing the RFID Sensor Assembly (A000365), Ribbon Encoder
Wheel (810492), Encoder Pulley (D900106) and Ribbon Supply Hub
(D900090)
Refer to Drawings D900077 and D900110.
Tools Needed: Torx T-10 Screwdriver, Retaining Ring
Pliers, Flat Head Screwdriver
Parts Needed: RFID Sensor Assembly (A000365),
Ribbon Encoder Wheel (810492), Encoder Pulley
(D900106) and Ribbon Supply Hub (D900090) Retaining
Clip 140048 (X2), Retaining Clip 140062 (X1)
Estimated Repair Time: 30 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066).
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148). See Replacing the Right End Cap (D900065-01 and –
02).
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092). See Replacing the Left End Cap (D900064).
5 Remove the Ribbon Supply Motor Assembly. See Replacing the Ribbon Take-
up Motor (D900086).
6 Use a Retaining Ring Pliers to remove the card feed gear (810266) retaining
ring (140048) and slide the gear off the Shaft.
Continued on the next page