Filter
Top Products
FS -8700-59 Canatal Sachnet Driver Manual
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: support@fieldserver.com
Page 13
Series Table Data Format Max Read Description Notes
5 10 CANA_PERCENT 4 R Analog Outputs
5 11 CANA_BYTE 48 RW Alarm Status
5 12 CANA_BYTE 3 R Control Status
5 13 CANA_BCD_CODED 7 RW Time
5 14 CANA_BYTE 4 R Staged Output Status
5 15 CANA_WORD 17 RW Accumulating Run Time
5 15 CANA_BYTE 1 RW Machine Remote Control
6 4 CANA_BCD_CODED 6 R FirmWare
6 5 CANA_BYTE 75 RW Keycode Mixed
6 6 CANA_SWAP_INT 7 R Sensor Reading
6 7 CANA_BCD_4 3 RW Security
6 8 CANA_BYTE 84 RW Time Schedule
6 9 CANA_BYTE 16 R Switched Output
6 10 CANA_PERCENT 4 R Analog Outputs
6 11 CANA_BYTE 241 RW Alarm Status
6 12 CANA_BYTE 10 R Control Status
6 13 CANA_BCD_CODED 7 RW Time
6 14 CANA_BYTE 4 R Staged Output Status
6 15 CANA_SWAP_INT 64 RW Accumulating Run Time
6 16 CANA_BYTE 1 RW Machine Remote Control
6 17 CANA_BYTE 7 RW KeyCode2 Mixed
9 4 CANA_BCD_CODED 6 R FirmWare
9 5 CANA_BYTE 75 RW Keycode Mixed
9 6 CANA_SWAP_INT 7 R Sensor Reading
9 7 CANA_BCD_4 3 RW Security
9 8 CANA_BYTE 84 RW Time Schedule
9 9 CANA_BYTE 16 R Switched Output
9 10 CANA_PERCENT 4 R Analog Outputs
9 11 CANA_BYTE 121 RW Alarm Status
9 12 CANA_BYTE 10 R Control Status
9 13 CANA_BCD_CODED 7 RW Time
9 14 CANA_BYTE 4 R Staged Output Status
9 15 CANA_SWAP_INT 64 RW Accumulating Run Time
9 16 CANA_BYTE 1 RW Machine Remote Control
9 17 CANA_BYTE 7 RW KeyCode2 Mixed
Mixed Data Formats: The drivers uses the Data Format listed in the above table as the default. If
you wish to poll data of different data types from one table then you will need at least two map
descriptors for that table. Example 2 in section 4.4.4 illustrates this. You will use the
cana_format parameter in the map descriptor to over-ride the default. Read the Canatal product
literature, determine the table storage format of the point(s) of interest and over-ride the default
format in your map descriptor. Note that map descriptors that include a range of points of mixed
data formats will cause unexpected results.