Filter
Top Products
FS -8700-59 Canatal Sachnet Driver Manual
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: support@fieldserver.com
Page 14
The Data formats are used internally in the driver but they do indicate to the user the type of data
array that should be used for storage in the FieldServer.
Data Type Suitable Data Array Types
CANA_BCD_CODED BYTE,UINT16,UINT32,FLOAT
CANA_BYTE BYTE,UINT16,UINT32,FLOAT
CANA_SWAP_INT SINT16, SINT32, UINT16,UINT32,FLOAT
CANA_BCD_4 BYTE
CANA_WORD UINT16,UINT32,FLOAT
CANA_FLOAT FLOAT
6.2 Troubleshooting
The following messages are produced by the driver. Those marked FYI are for the user's
information only and do not require any corrective action. Those marked Error require some
action from the user.
CANA:#1 FYI. Station illegal -Forcing from %d to 59
Valid station numbers are 1-63.
CANA:#2 Error. Series & table numbers are rqd. Correct MapDesc=<%s>
The series and table parameters cana_series and cana_table must be specified in
the map descriptors.
CANA:#3 Error. Illegal Series Number. Correct MapDesc=<%s>
The series number specified cannot be processed by this driver. Read the vendor
documentation and correct the CSV file.
CANA:#4 Error. Illegal Table Number(%d). Correct MapDesc=<%s>
All Canatal equipment series do not have the same number of tables. Read the
vendor documentation and correct the CSV file.
CANA: #5 Error. Series & table numbers are rqd. Empty Table. Correct MapDesc=<%s>
The series & table combination specified are not valid. Read the vendor
documentation and correct the CSV file.
CANA:#6 Error. Start address is beyond end of table. MapDesc=<%s>
The address is the equivalent term to offset in the Vendor literature. Different
tables have different lengths. The lengths may also be different based on the
series number of the equipment. Read the vendor documentation and correct the
CSV file.
CANA:#7 FYI. Requested too many elements from table. MapDesc=<%s>
Changed request from %u to %u
The driver has truncated you data_length so that it does not read/write beyond the
end of a table.