Filter
Top Products
FS -8700-59 Canatal Sachnet Driver Manual
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: support@fieldserver.com
Page 15
Errors 8 - 12 are produced when parsing a response from a Canatal device. They may result from
a corrupted message. If they occur infrequently then they require no attention. Check the
communication stats. In fact, it is more likely that you will be alerted to them by seeing errors in
the communication statistics.
CANA:#8 Error. Poll(%d)/Response(%d) Stns Not Equal
The station polled has response but as a different station. The response will be
abandoned. This may mean that the device's address has been incorrectly set or
that the device is not functioning correctly.
CANA:#9 Error. Poll(%d)/Response(%d) Tables Not Equal
CANA:#10 Error. Response Table=%d Unknown
CANA:#11 Error. Poll(%d)/Response(%d) Address Not Equal
CANA:#12 Error. Response Expected(%d)/Actual(%d) Bytes
CANA:#13 Error. Array is too small for mapDesc=<%s>
Some data will not be stored.
This is regarded as an error as the map descriptor has requested more data than can be stored. The
excess data has been discarded. The user should modify the map descriptor definition or change
the array length in the CSV file and restart the FieldServer.
CANA:#14 Error. Unknown Data method (%d) for mapDesc=<%s>
Report this error to FIELDSERVER TECHNOLOGIES.
CANA:#15 Error. Unknown Data method (%d) for mapDesc=<%s>
Report this error to FIELDSERVER TECHNOLOGIES.
7. Version Control
Date Driver
Version
Document
Revision
Responsible Comment
1.00a 0 Initial Release
1.00b 1 Minor changes in the way offset was described
in the examples in section 4.4.4 and 5.4.4
Driver changes are described in Technical
Bulletin TB0001.
5Apr2002
1.00b 2 Corrected some table numbers in section 6.1.
Previously table 16 & 17 had been shown as
table 15 & 16.
11/22/02 1.00b 3 MF Formatting changes
3/13/03 1.00b 4 JD Formatting changes