Filter
Top Products
25
COMPUTER MODE
MANUAL PC ADJUSTMENT
This projector can automatically tune to the display signals from most personal computers currently distributed. However,
some computers employ special signal formats which are different from the standard ones and may not be tuned by Multi-
Scan system of this projector. If this happens, projector cannot reproduce a proper image and the image may be recognized
as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.
This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those special
signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This
enables you to recall the setting for a specific computer whenever you use it.
Note : This PC ADJUST Menu cannot be operated when “RGB” is selected on SYSTEM Menu (P23, 24).
Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT button to move a red frame pointer to PC
ADJUST Menu icon.
1
2
Press POINT DOWN button to move a red frame pointer to the
item that you want to adjust and then press SELECT button.
Adjustment dialog box will appear. Press POINT LEFT/RIGHT
button to adjust the value.
Move the red frame icon to the item and
press SELECT button.
PC ADJUST MENU
PC ADJUST
Menu icon
Adjust the picture as necessary to eliminate flicker from the display.
Press POINT LEFT/RIGHT button to adjust value.(From 0 to 255.)
Fine sync
The number of total dots in one horizontal period. Press POINT
LEFT/RIGHT button(s) and adjust number to match your PC image.
Total dots
Adjust horizontal picture position. Press POINT LEFT/RIGHT
button(s) to adjust the position.
Horizontal
Adjust vertical picture position. Press POINT LEFT/RIGHT button(s)
to adjust the position.
Vertical
Press SELECT button to show the information of computer selected.
Current mode
The number of the total horizontal lines. Press POINT LEFT/RIGHT
button(s) and adjust number to match your PC image.
Total lines
Adjusts clamp level. When the image has a dark bar(s), try this
adjustment.
Clamp
Press SELECT button at this icon to
adjust “Total lines,” “Clamp,” “Display
area,” “Horiz. scale” or “Vert. scale” .
Press POINT LEFT/RIGHT
button to adjust the value.
Press SELECT button at
Current mode icon to show
the information of computer
connected.
Shows the status
(Stored/Free) of
Mode.
Selected Mode