Filter
Top Products
37
This function turns Projection Lamp off when projector detects signal
interruption and projector is not used for a certain period in order to
reduce power consumption and maintain the Lamp-life. (This
projector is shipped with this function ON.)
Power Management function operates to turn Projection Lamp off
when the input signal is interrupted and projector is not operated
over 5 minutes. This function operates as follows;
1. When the signal is interrupted, “No signal” and the counting
down display appears (for 5 minutes).
2. When Projection Lamp turned off, READY Indicator turns off.
Cooling Fans operate and Projection Lamp is turned off for 90
seconds. (During this "Cooling Down" period, projector cannot
be turned on.)
3. When Projection Lamp has cooled down, READY Indicator
flashes and Projection Lamp can be turned on again (Power
Management mode).
In this Power Management mode, Projection Lamp is
automatically turned on when the input signal connected or
projector is operated with any button on the Top Control or on
the Remote Control Unit.
Power management
This function is used to reset Lamp Replace Counter. When
replacing Projection Lamp, reset Lamp Replace Counter by using
this function. Refer to page 39 for operation.
Lamp counter reset
SETTING
Remote control
This projector has two different remote control codes; the factory-set
normal code (Code 1) and the secondary code (Code 2). This
switching function prevents the remote control operation mixture
(jam) when operating several projectors or video equipment together.
When operating projector in “Code 2,” both projector and Remote
Control must be switched to “Code 2.”
To change the code of Projector;
Set the Remote control in the SETTING MENU to “Code 2.”
To change the code of the Remote Control;
Press both MENU and NORMAL buttons on the Remote Control
Unit together for over 10 seconds.
After changing the code, make sure the Remote Control operates
properly.
To return to the normal code (Code 1), operate both projector and
Remote Control in the ways above again.
NOTE : When batteries of the Remote Control Unit is replaced, the
remote transmit code automatically returns to the normal
code (Code 1).
On start
When this function is “On,” projector is automatically turned on just
by switching MAIN ON / OFF SWITCH on.
Note ; Be sure to turn projector off properly (refer to the section
“TURNING OFF THE PROJECTOR” on page 20.). If
projector is turned off in the wrong steps, On Start function
does not operate properly.
Time left until Lamp off.
Move the pointer to the item
and then press POINT
LEFT/RIGHT button(s).
Move the pointer to Lamp counter reset and then press
SELECT button. The message “Lamp replace counter
reset?” is displayed.