Filter
Top Products
P-Series Installation and Operation Guide, version 2.3.1.2 105
• Load the rule firmware
• Load the capture/block configuration
• Load the runtime parameters
• Enable the network interface
Syntax
pnic restart
Command
History
Example
Figure 70
[root@localhost SW]# pnic restart
No card number specified. Assuming card 0
Interface pnic0 is down
Waiting for matching to stop...
Loading rule firmwares............ Done.
Loading pass/block settings... Done.
Loading dynamic rules... Done.
***************************************
Interface pnic0 is up
MTU set to 9264 bytes
***************************************
Version : P_MAIN2.2.0.058
[root@localhost SW]#
pnic restart Command Example
Usage
Information
restart always reloads the FPGA, as opposed to start which does not load the FPGA if
firmware is already present.
Related
Commands
pnic sguil-sensor-start
Start the Sguil sensor.
Note: Essentially, this command performs the command pnic stop followed by the
command pnic start.
Version 2.0.0.1 Introduced
pnic stop Disable the network interface.
pnic start Enable the network interface.