FortiSwitch-5003A System Guide
12 01-30000-77803-20080917
FortiSwitch-5003A configurations FortiSwitch-5003A system
Layer-2 link aggregation and redundancy configurations
The FortiSwitch-5003A board supports 802.3ad layer-2 link aggregation, 802.1q
VLANs, and 802.1s Multi-Spanning Tree Protocol (MTSP) for the fabric channels.
You can use these features to configure link aggregation and support redundant
FortiSwitch-5003A switch configurations to distribute traffic to multiple
FortiGate-5000 boards.
See the FortiGate-5000 Backplane Communication Guide for more information
about FortiSwitch-5003A link aggregation and redundancy.
Figure 6 shows a basic link aggregation configuration using a single
FortiSwitch-5003A board. In this configuration the external switch is connected to
FortiSwitch-5003A front panel f5 interface. The switch adds VLAN tags to traffic
from the internal and external networks.
Figure 6: Basic link aggregation configuration
1
2
2
3
4
5
SMC
1
SMC
POWER
5050SAP
SERIAL
1
SERIAL
2
ALARM
10/100
link/Act
ETH0
Service
RESET
STATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
10/100
link/Act
ETH0
Service
RESET
STATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
Distributed 10-gigabit
Data Communication
on Fabric Channel 2
Three FortiGate-RTM-XB2
modules installed in RTM
slots 3, 4, and 5 to
provide 10-gigabit
fabric interfaces and
NP2 acceleration for each
FortiGate-5001A board.
External
Network
Internal Network
Internal and External
10 Gigabit Networks
Connected to
FortiSwitch-5003A
Front Panel Interface F5
and to Fabric Channel 2
External Switch
VLAN
Tagged
Traffic