Filter
Top Products
2-8
Using the Stylistic 1200 Pen Tablet
• The system uses a small amount of battery power when in Suspend-to-RAM
mode. Eventually, the battery will become fully discharged. If you will not be
using the system for an extended period of time, shut down the system and turn
off the Power switch rather than using Suspend-to-RAM mode.
• If the battery pack charge drops to the Low-Battery Warning level while the
system is in Suspend-to-RAM mode, the system will beep periodically. If this
occurs, either resume system operation and shut down the system or attach an
external power source, such as the AC adapter, to the pen tablet.
• If the battery charge drops to the Critically Low level while the system is running,
the system is forced into Suspend-to-RAM mode. If this occurs, you must either
install a charged battery pack, or connect an appropriate external power source
such as the AC adapter before you can resume system operation.
• Suspending system operation interrupts data communications; however, some
programs may block the system from suspending to prevent interrupting
processes with a higher priority (such as data communications).
• The Suspend/Resume button on your system may be disabled. If this is the case,
pressing the Suspend/Resume button may not suspend system operation as
described here. Contact your local help desk or reseller if your system
configuration is not suitable.
• If your system is equipped with a PC Card that allows you to connect to a wired
or wireless network, you may be logged off the network after a period of
inactivity while system operation is suspended. Contact your network
administrator or local help desk for details on log-off parameters for your
network.
Resuming System Operation 2
To resume system operation:
1. Choose one of the following, depending on the suspend mode your system is in.
• Suspend-to-RAM mode: Press the Suspend/Resume button.
After a few seconds, the system returns to the Fully On state and system
operation resumes.
• Suspend-to-Disk mode: Press the Suspend/Resume button or, if the Power
switch is in the Off position, turn on the Power switch. Active data is read
from the hard disk drive and after several seconds, the system returns to the
Fully On state.