Filter
Top Products
BX960 S1 Operating Manual 13
Performance features
– 10 Gbit/s Ethernet mezzanine card with 2 ports (Intel 82599EB controller)
– 8 Gbit/s fiber-channel card with 2 ports (compatible with Emulex LPe12002)
I If a server blade is configured with up to four mezzanine cards, this does
not exclude other configurations for any of the other server blades in a
BX900 S1 system unit.
If you want to install mezzanine cards in server blades, the system unit
must be fitted with the corresponding Fibre Channel, Infiniband and/or
Ethernet connection blades. You can find detailed information about the
equipping rules for connection blades in the operating manual for the
BX900 S1 system unit.
Mezzanine cards may only be installed and removed by authorized,
qualified personnel. The procedure is described in the options guide.
SSD drives
Two SSD drives (Solid State Disk drives) can be installed in the server blade.
The SSD drives are mounted at the place of mezzanine card 1, using a special
mezzanine card carrier. The connection to the onboard controller is established
through a riser card. The installation procedure is described in the options
guide.
A UFM (USB flash module) can also be configured.
SATA-RAID support
RAID levels 0 and 1 are supported for operation of the SSD drives.
For more information on configuring the controller, see section "onboard SATA
controller, configuring" on page 48.
Graphics controller
The server blade has an onboard graphics controller (integrated in the iRMC S2
controller). A monitor can be connected via the Y cable on the front of the server
blade.
External ports
The server blade has a port for a special Y cable on the front, with 4 USB ports,
one serial port and one VGA port.