Filter
Top Products
30
ii. When a cascade connection is used
The server can be selected by pressing the [ServerSelection] switch.
When this switch is pressed, servers without power can also be selected.
When M1 (as shown in the diagram below) is selected and the [ServerSelection] switch (right)
is pressed, S1 is selected.
In addition, when M1 is selected and the [ServerSelection] switch (left) is pressed, M8 is
selected.
When the [ServerSelection] switch is pressed for a long time, key typer and server quick
selection can be operated.
If the eighth port of the master side is being used for a cascade connection, the selection
operation is stopped at the port with the largest number on the slave side that is connected to
the eighth port of the master side.
If the first port of the master side is being used for a cascade connection, the selection
operation is stopped at the first port on the slave side that is connected to the first port of the
master side.
In addition, only server selection on the cascading side can be performed by [ServerSelection]
switch operation on the cascading side.