Fujitsu M200 Computer Hardware User Manual


 
14.3 Initial Diagnosis Sequence
14.3 Initial Diagnosis Sequence
LCD display Sequence
The LCD display sequence is shown in the Figure 14.1 . There are many patterns in the second line.
But, the following example shows only some of them.
SCF:initial
I/O Power on
POST:Executing#
test_name
OBP:Initializing
Just a moment
Operating System
POST:ERR########
component
diagnostic alarm
diagnostic stop
POST:ERROR STOP
########: error code
OBP stop
OBP:STOP
check error logs
ex: Probing Memory
Probing CPU
Probing PCI
Scrubbing Memory
Booting
ex: Check error logs
RED state trap
Reset swich
Figure 14.1 Power-on Sequence
Note that if hardware error is found during the power-on sequence, GP7000F main cabinet is power
cycled automatically to make sure any error detected during the power-on sequence.
If power-up processing is not performed after turning on the power switch, check to see if the AC
main line switch is in the proper position and that the mode switch is set to SECURE.
159