CHAPTER 3 M200R Main Cabinet
3.6 Installation
Purpose The following installation instruction is intended to provide the product safety requirements which
must be addressed when the end-use product manufacturer installs this product in their equipment.
Note that the acceptability of the combination of this product in a rack should be re-determined by
an appropriate certification body, if that combination is differ from the Table 3.4 .
Safety Installation Instruction:
This unit is installed in a closed or multi-unit rack assembly, the operating ambient temperature
inside of the rack environment may be greater than room ambient. Therefore, consideration
should be given to installing the unit in an environment compatible with the manufacturer’s
maximum rated ambient temperature.
– Consideration for adjustment of air condition like air circulation should be given to prevent
the internal rack ambient from exceeding the Max. Operating ambient temperature of this
unit.
– Maximum operating ambient temperature of this unit : 35 deg C.
Installation of the unit in a rack should be such that the amount of air flow required for safe
operation of the unit is not compromised.
– This unit has ventilation openings at front and rear face of the unit.
– Do not cover or close these ventilation openings to prevent overheating.
Mounting of the unit in the rack should be such that a hazardous condition is not achieved due
to uneven mechanical loading. To keep stability of entire rack, please fix the rack to wall or
floor by suitable means.
– Be careful about injury during installation of this unit into rack.
– Do not install this unit into your rack where the unit may make the entire rack unstable.
– Mass of this unit with maximum configuration : 40 kg.
If the unit is supplied from Power Strip or Service Outlet of other units, it may overload the
Power Supply Cord of the Power Strip or other units.
– Confirm that the current rating of Power Strip or Service Outlet exceeds the combined
ratings of all equipment it is supplying.
– Electrical ratings of this unit : Rated 100 - 240Vac, 4.0 - 1.5 A, 50/60 Hz, 1 phase
Reliable earthing of rack-mounted equipment should be maintained. Particular attention should
be given to supply connections other than direct connections to the branch circuit (e.q., use of
power strips).
36