Filter
Top Products
CHAPTER 12 External Interface
Chapter 12 explains the external interface of the main cabinet such as UPS Control Interface,
RS232C Interface, and Centronics Interface.
CHAPTER 13 RCI Setting
Chapter 13 explains the description of RCI commands to be used for managing nodes.
CHAPTER 14 Troubleshooting
Chapter 14 will help the user isolate the cause of system failures, and provides suggested solutions.
Conventions for Warning Messages
A warning message consists of a signal and statements. The signal consists of a symbol and a signal word or just a
signal word.
The following are the signals and their meanings:
CAUTION
This indicates a hazardous situation could result in minor or moderate personal injury if the user
does not perform the procedure correctly. This signal also indicates that damage to the product or
other property, may occur if the user does not perform the procedure correctly.
IMPORTANT
This indicates information that could help the user use the product more efficiently.
In the text, the signal is centered, followed below by the indented message. A wider line space precedes and
follows the message to show where the message begins and ends. The following is an example:
(Example)
CAUTION
Data destruction: Do not press these buttons before installing the necessary
software package. Otherwise, data may be destroyed. Turn off the system in the
OBP prompt state if the software package is not installed.
Attention
Please forward any comments you may have regarding this manual.
To make this manual easier for users to understand, opinions from readers are needed. Please write your opinions
or requests on the "Comment Form" sheet at the back of this manual and forward it to the address provided on the
sheet.
vi