Filter
Top Products
CHAPTER 4 M400A Main Cabinet
4.6 Installation
Notes on installation:
Do not block the ventilation slits.
Do not install the M400A main cabinet where it will be exposed to sunlight or sources of heat.
Do not install the M400A main cabinet in dusty places or places where it will be exposed to
corrosive gas or sea breeze.
Keep the M400A main cabinet isolated from vibration. Install the M400A main cabinet on a
level surface so that it does not tilt.
Make sure that the AC power supply source is grounded properly. Otherwise, the M400A main
cabinet may malfunction.
Do not run a cable under a unit or allow a cable to become taut. Do not disconnect the power
cable when the power is on.
Do not place anything on the M400A main cabinet. Do not use the cabinet of the M400A main
cabinet as a work space.
In winter, to prevent condensation in the M400A main cabinet, do not raise the ambient
temperature rapidly. Use the M400A main cabinet only after it has warmed up sufficiently.
Do not install the M400A main cabinet near a noise generating device such as a photocopier, air
conditioner, or welder.
Take electrostatic prevention measures. Note that some carpets generates static electricity
easily and can cause the M400A main cabinet to malfunction.
When moving the M400A main cabinet, do not pull on the front cover. Otherwise, the main
cabinet may be damaged.
IMPORTANT
If the above conditions are not satisfied, the M400A main cabinet may be damaged. Be
sure to follow these precautions.
50