Filter
Top Products
C141-E035-01EN 5 - 1
CHAPTER 5 INSTALLATION
5.1 Notes on Handling Drives
5.2 Connections
5.3 Setting Terminals
5.4 Mounting Drives
5.5 Connecting Cables
5.6 Confirming Operations after Installation and Preparation
for Use
5.7 Dismounting Drives
This chapter describes the notes on handling drives, connections, setting switches and plugs, mounting
drives, connecting cables, confirming drive operations after installation and preparation for use, and
dismounting drives.
5.1 Notes on Handling Drives
(1) General notes
a) Do not give the drive shocks or vibrations exceeding the value defined in the standard
because it may cause critical damage to the drive. Especially be careful when unpacking.
b) Do not leave the drive in a dirty or contaminated environment.
c) Since static discharge may destroy the CMOS semiconductors in the drive, note the
following after unpacking:
• Use an antistatic mat and body grounding when handling the drive.
• Hold the DE when handling the drive. Do not touch PCAs except for setting.
(2) Unpackaging
a) Use a flat work area. Check that the "This Side Up" sign side is up. Handle the package
on soft material such as a rubber mat, not on hard material such as a desk.
b) Be careful not to give excess pressure to the internal unit when removing cushions.
c) Be careful not to give excess pressure to the PCAs and interface connector when removing
the drive from the antistatic bag.
d) Do not remove the sealing label or cover of the DE and screws.