Filter
Top Products
C141-E235 IN-1
Index
A
AC noise filter ................................................ 4-9
actuator........................................................... 1-6
air circulation.................................................. 1-6
allowable input voltage and current................ 4-8
alternate area................................................... 3-9
alternate block allocation.............................. 3-10
alternate block allocation by FORMAT
UNIT command...................................... 3-11
alternate block allocation by REASSIGN
BLOCKS command................................ 3-12
alternate block allocation during
FORMAT UNIT command execution.... 3-11
alternate cylinder ............................................ 3-4
alternate spare area ......................................... 3-4
automatic alternate block allocation............. 3-13
automatic alternate block allocation at
read operation ......................................... 3-13
automatic alternate block allocation at
write operation........................................ 3-13
automatic alternate block reassignment.......... 1-4
B
basic operation test ......................................... 6-5
BCRC ............................................................. 3-7
block address of user space ............................ 3-9
block descriptor.............................................. 5-9
C
cache feature................................................... 1-3
caching parameter......................................... 5-14
changing revision number in field.................. 6-8
checking at abnormal end............................... 5-9
checking connection....................................... 5-6
checking HDD connection ......................5-7, 5-8
checking initial operation ............................... 5-5
checking operation after installation and
preparing IDD for use............................... 5-5
checking procedure......................................... 5-6
command queuing feature .............................. 1-3
compactness.................................................... 1-2
connection requirement .................................. 4-9
connector ........................................................ 4-9
continuous block processing........................... 1-2
controller circuit ............................................. 1-6
current waveform ........................................... 4-8
cylinder configuration .................................... 3-1
D
data field .........................................................3-7
data format......................................................3-1
data security at power failure..........................2-7
data space........................................................ 3-1
defect list.......................................................3-10
defect management.......................................3-10
defective block slipping..................................1-4
definition of sense data...................................7-3
delivery...........................................................5-2
diagnosis.........................................................1-5
diagnostic........................................................6-1
diagnostic test ............................................... 6-11
diagnostics and maintenance ..........................6-1
disconnection/reconnection parameter .........5-13
disk ................................................................. 1-5
disk drive replacement....................................6-7
disk drive troubleshooting ............................ 6-14
disk read error.................................................7-4
dismounting drive......................................... 5-16
dual-port support ............................................ 1-2
E
ECC ................................................................3-7
enclosure service function .............................. 1-3
environmental magnetic field ......................... 4-7
environmental specification............................2-4
environmental temperature.............................4-5
environmental/power requirement..................2-4
error analysis...................................................7-1
error analysis information collection..............7-1
error information indicated with sense
data............................................................7-3
error rate .........................................................2-5
error recovery .................................................1-4
error recovery during self-diagnostic..............6-3
error recovery parameter ..............................5-12
example of FC-AL system configuration .......1-7
external dimension.......................................... 4-1
F
factory maintenance........................................ 6-7
FC model drives outer view............................ 1-5
FC-AL standard.............................................. 1-2
FC-SCA connector......................................... A-2
fibre channel interface error ...........................7-4
field maintenance............................................ 6-7
finding possibly faulty part........................... 6-15