Filter
Top Products
Sense Data and Error Recovery Methods
368 C141-C013
Table 6.4 Additional Sense Code and Additional Sense Code Qualifier (4/6)
C* Q*
Name Explanation
Sense
key
00 Medium format corrupted The media format is different from the original format. (The
media was not formatted after the data format specification was
changed by the MODE SELECT command.)
3 31
01 FORMAT command failed For some reason, formatting cannot be completed and
reformatting is necessary.
3
00 No defect spare location
available
No usable alternate block area exists. Or alternate block
processing cannot be performed due to control table overflow.
4 32
01 Defect list update failure Updating of the defect list (G List) failed. 4
37 00 Rounded parameter Rounding processing of the MODE SELECT parameter
specified by the command was performed.
1
03 Logical unit failed Self-Test The test segment error occurred during the Self-Test 4 3E
04 Logical unit unable to update The HDD failed to update the Self-Test result log 4
01 Microcode has been changed Microcode was changed by another INIT. 6
02 Changed operating definition Operating definition was changed. 6
3F
05 Device identifier changed Device identifier was changed. 6
40 nn Diagnostic failure on
component "nn"
An error was detected in self-diagnosis. ("nn" is a Fujitsu unique
code)
• 81: Buffer RAM compare error/bus error
• 83: HDC register check error
• 84: Firmware header/check sum error
• 86: Parameter header/check sum error
• 88: Drive Serial No. unmatch
• 89: DE type unmatch
• 8F: Other MPU peripheral circuit diagnostic error
• 92: Spindle motor firmware initialize error
4
* C: Additional Sense Code, Q: Additional Sense Code Qualifier