Filter
Top Products
6.1 Sense Data
C141-C013 367
Table 6.4 Additional Sense Code and Additional Sense Code Qualifier (3/6)
C* Q*
Name Explanation
Sense
key
01 Primary defect list not found The defect list (P List) header is incorrect. 3
02 Grown defect list not found The defect list (G List) header is incorrect. 3
1C
80 SA information list not found The SA information (MODE SELECT parameter) header is
incorrect.
3
00 Miscompare during verify
operation
Comparison of data transferred from the INIT by a VERIFY
command (when the Byte Check mode was specified) with data
read from the disk media was terminated unsuccessfully.
E 1D
80 Miscompare during self-
configuration
There is an unmatch to compare read data with write data during
self-configuration.
E
1F 00 Partial Defect List Transfer Read Defect Data command (37h) cannot transfer all the Defect
data in the target because the numbers of defect exceeded the
maximum.
1
20 00 Invalid command operation
code
CDB byte 0 (operation code) is illegal. 5
21 00 Logical block address out of
range
A logical block address which exceeds the drive's maximum
value was specified.
5
24 00 Invalid field in CDB There is an error in a specification in the CDB. 5
25 00 Logical unit not supported An illegal LUN was specified. 5
26 00 Invalid field in parameter list There is an error in the parameter list specifications transferred
from the INIT during command execution.
5
27 00 Write protected A write operation was attempted in a write protected area. Or a
write operation is prohibited at the external operation panel.
7
29 01 Power on occurred Microcode was downloaded immediately after power on. 6
02 SCSI Bus Reset Occurred A HARD_RESET primitive was received. 6
03 TARGET RESET function
occurred
A Logical Unit RESET was received. 6
04 Firmware Internal Reboot Reboot occurred in the firmware 6
07 I_T Nexus Loss occurred I_T Nexus Loss Time (Mode Page 19) was expired. 6
01 Mode parameter changed The MODE SELECT parameter values were changed by another INIT. 6
03 Reservations preempted A persistent reserve state was cleared by another INIT. 6
04 Reservations released A persistent reserve state was released 6
2A
05 Registrations preempted A persistent reserve state was preempted by another INIT. 6
2F 00 Command cleared by another
INIT
A command was forcibly terminated by another INIT during
execution or queuing.
• By a CLEAR TASK SET
• The sense hold state was entered when the QErr bit was set on
"1."
6
* C: Additional Sense Code, Q: Additional Sense Code Qualifier