Filter
Top Products
6
n
Validation interval at automatic shutdown
This setting required for the use of UPS.
For details about various settings, refer to "3.4 UPS Settings" in the "User's Guide". The numbers in brackets ( ) are setting
examples.
Item Actual Setting Parameters Time
Validation interval from the power failure
to the start of FTvirtual Server shutdown
"Power Failure" - "When power fails, begin a shutdown
procedure:" - "After UPS has been on battery for" in
Device Properties.
minutes
(1 min)
Validation interval from the start of FTvirtual
Server shutdown to the start of CoServer
shutdown (Command le execution time)
Select Device properties "Shutdown Sequence" -
"Congure Shutdown Sequence" - "Next" - "OS" and
then "Delay".
minutes
(3 mins)
Validation interval from the start of CoServer
shutdown to UPS power off (time required for
OS shutdown)
Select Device properties "Shutdown Sequence" -
"Congure Shutdown Sequence" - "Next" - "OS" and
then "Duration".
minutes
(1 minute
30 seconds)
Total
minutes
seconds
(5 minutes
30 seconds)
n
Network conguration
CoServer Link1, CoServer Link2, Virtual Network1 and Virtual Network2 are internal network settings. Normally modi-
cations are not required.
However, when there is a conict with an external network, refer to "3.2 Network Functions" in the "User’s Guide" before
setting. Figures in the brackets ( ) are default values.
Item
FTvirtual Server
IP address Subnet mask
Computer name
Local area connection (FTvirtual Server LAN)
.
.
. .
.
.
Virtual Network1 (192 . 168 . 181 . 81)
(255 . 255 . 255 . 252)
Virtual Network2 (192 . 168 . 181 . 85)
(255 . 255 . 255 . 252)
Item
CoServer1 (FT1) CoServer2 (FT2)
IP address Subnet mask IP address Subnet mask
Computer name
CoServer Management
(CoServer LAN)
.
.
.
.
.
.
.
.
.
.
.
.
CoServer Link1 (
192 .168 .181 . 89
) (
255 .255 .255 .252
) (
192 .168 .181 . 90
) (
255 .255 .255 .252
)
CoServer Link2 (
192 .168 .181 . 93
) (
255 .255 .255 .252
) (
192 .168 .181 . 94)
(
255 .255 .255 .252
)
Virtual Network (
192 .168 .181 . 82
) (
255 .255 .255 .252)
(
192 .168 .181 . 86
) (
255 .255 .255 .252
)
When setting, the FTvirtual Server LAN adapter appears (Redirected 0) on the CoServer, but it is reserved because it is
used by the FTvirtual Server.
Do not bind internet protocol (TCP/IP) and do not set IP addresses or subnet masks to these adapters on the CoServer.
Set the FTvirtual Server LAN IP address and the subnet mask on the FTvirtual Server.