Filter
Top Products
6 Gateway ALR 7200 User’s Guide
Powering Up the System
Press the On/Off switch on the front panel, and the green LED on the front
panel will illuminate ON.
If you turn off your system, you must wait at least ten seconds before you
turn the system back on.
The system self-checks the memory even if the monitor is not connected. If
the monitor is connected and powered ON, the screen displays the power-up
sequence.
• If more than one CPU is installed, the system displays which CPU
it is currently testing.
• If any errors are encountered, your system displays them on the
monitor.
• If a monitor is not connected or the system is unable to display an
error, an error beep code sounds.
• If the system encounters an error, it is most likely a nonfatal one,
meaning the system will function until the error can be corrected
(usually through the BIOS Setup).
Quick Check
If your system does not operate correctly, re-read the instructions for the
procedure(s) you have performed. If an error occurs within an application,
consult the documentation supplied with the software.
This section identifies solutions to common problems. If the suggestions in
this section are not helpful, try looking up the problem in the
Maintaining
and Troubleshooting Guide
. In the event of a problem, the following checks
should be performed:
Warning!
The bezel door must be
closed and locked while the
system is running.
Note:
Under no circumstances
return any equipment
without obtaining a Return
Material Authorization
(RMA) number.
3435.boo Page 6 Thursday, August 6, 1998 7:12 AM