Filter
Top Products
109
www.gateway.com
Troubleshooting Your Ethernet network
Wired Ethernet network
You cannot see the other computers on your network
■ Make sure that your Ethernet cable is plugged into the Ethernet jack on your computer.
Make sure that the other end is plugged into a router.
■ Make sure that all computers are plugged into a powered electrical outlet and turned
on.
■ Make sure that the router is plugged into a powered electrical outlet and turned on.
Most routers have lights that indicate they are working. For more information, see
the documentation that came with your router.
■ Make sure that all computers on your network have the same workgroup name.
■ Make sure that all computers are using the same Subnet Mask.
■ If you assigned IP addresses to the computers, make sure that all computers have
different IP addresses. For home networks, IP addresses should be 192.168.N.N where
N is a number you assign between 0 and 254. The first N should be the same for all
computers on your network and the second N should be different for all computers
on your network.
The computer does not recognize an add-in Ethernet card
■ Shut down and restart your computer.
■ Make sure that you have installed the required software. For more information, see
the documentation that came with your Ethernet card.
■ Reseat the card. For more information, about opening your computer case, see
“Opening the case” on page 46. For more information about your Ethernet card, see
the documentation that came with your Ethernet card.
Your wired Ethernet network is running slower than you expect
■ If your wired Ethernet network is running slower than you expect, check the speed
of each Ethernet component. For best results, all Ethernet components should be
standard Ethernet (10 Mbps), Fast Ethernet (100 Mbps or 10/100 Mbps), or Gigabit
Ethernet (1000 Mbps or 10/100/1000 Mbps). A mixture of Ethernet, Fast Ethernet, and
Gigabit Ethernet components will result in your network running at the slowest
component speed.